你抽的越快我声音越大

Hello! Welcome to Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd!

18912476492

LOCATION:Home>>news>>Industry Dynamic>>High - speed automatic die - cutting machine

Contact Us

C

Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd

Tell :0510-88991997

Fax :0510-88991997

Phone:18912476492

E-mail:rtxcsales@rtxcnu.com

Url      :www.rtxcnu.com

Zip Code:214000

Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City


Industry Dynamic
分享至:

High - speed automatic die - cutting machine

DateTime:2019/12/03

  High speed automatic die-cutting machine in the adjustment of the machine to pay attention to what? In the usual work, die-cutting master of the actual operation of the automatic die-cutting machine and the basic way of adjustment have a certain grasp.

Only grasp the key links and solutions, can make the work more clear, more efficient.

Automatic die-cutting machine die-cutting equipment, including the upper template, the lower template and the mold set on the upper template, to solve the problem of raw material layout in the lower template in the middle of the production and processing of raw materials, in the production and processing of raw materials under the setting to adjust the deep layer of the soft cushion, the soft cushion can not be produced and processed, reduce the product cost.

The key to the adjustment of working pressure is the deep adjustment of die cutting die frame.

After installing a special tool, one must adjust the base of the mold to see if the mold can laser cut the raw material properly.

During the whole process of working pressure adjustment, it is forbidden to open the hole in single position or in tandem.

Only when the machine and equipment are adjusted to the manual gear can the test and adjustment be carried out.

When adjusting to today's schedule, the mold transparent retenter is still unable to reasonably laser cut raw materials, should be re-implemented work pressure adjustment.

Select the suitable automatic die-cutting machine template according to your mould (for tablet computer die-cutting machine, the key is the upper template, thick, medium and thin: thick steel plate is suitable for plastic plate mould, medium thick plate is equipped with AB mould, metal sheet is used for wood and manual engraving plate).

High die cutting machine die base, so that it has been installed in the application of the mold of the width and height ratio of indoor space (to put it bluntly, die cutting relief pressure, filling to the bottom point).

Clean the left and right base of the die cutting machine to ensure that the surface of the work to maintain the flatness of the die.

Scrape the bottom plate down with the tip of the knife until it is parallel to the bottom.

(The whole process of refit, charging, stability test, etc., pay attention to wide and flat adjustment when scraping the line, to prevent the formation of small concave and uneven lines.) Adjust the mold to scrape a large number of protective cushion blocks.

Depending on the specific situation, lift the single and double sides of the tape over a small part, and fill one of these parts with 1-2 layers of tape.

contact us

Tell :0510-88991997

Fax :0510-88991997

Phone:18912476492

Phone:18661000660

E-mail:rtxcsales@rtxcnu.com

Url      :www.rtxcnu.com

Zip Code:214000

Address:No. 81, Jinma Road, Hongshan Street, Xinwu District, Wuxi City

Copyright (c) Jiangsu Runtian Xincheng Intelligent Technology Co., Ltd All rights reserved 蘇ICP備2020051884號-2
网站地图